More Busa Work

I've spent the last couple of weeks continuing to strip the bike engine.

I managed to get hold of a good workshop manual that has a step-by-step guide on removing the engine which I'm following religiously. On top of that, I'm labeling everything, although I'm labeling it with what I think it is, so as long as I still think it's that when I'm connecting it back up again, I'll be ok.

Obviously there have been a few incidents along the way, luckily there have been no more smashing lights however. In getting the fuel tank off, I had to clamp some pipes to stop the fuel spilling. It turns out that cable ties aren't adequate for clamping pipes so there was a minor fuel spillage on my garage floor. Never mind, it probably needed a wash anyway.

Next, the radiators had to go, yes, I spilt the coolant too. My garage floor is now spotless. But off came the rad and a bunch of other bits too.

I drained the oil, I'm learning, I didn't spill that, in fact I left it draining for a few hours while I carried on and then put the oil screw back in finger tight and locked up one night. Next morning there was oil all over the floor, apparently finger tight isn't good enough and there was still some oil in the system. Now you thought my floor was clean before? It could now double as a set in a Mr. Muscle advert.

Proper engine bits here!

Anyway, back to pulling bits off the bike. It's quite an enjoyable task, and it really makes you appreciate the work that goes into designing the things. It's a 14 year old design but it's also still a 200mph bike and there are sensors just about everywhere. I take my hat off to Suzuki. 

Ooops

Along the way there was one mishap with one of the manifold bolts, it kind of broke which is going to be a real pain to get out, I'll wait until the engine is out I think as it's at an awkward angle to work at.

The workshop manual has 12 pages on how to remove the engine, although some of the bullet points refer you to another section which is another 4 pages long. However, I've broken the back of it now, and I think I'm probably only about an hour away of getting the lump out.

So why stop I hear you ask?
Well, because of torque. You see, although I now boast a moderate toolkit, I don't have any BIG tools, like 32mm and 36mm sockets needed for the front sprocket and rear axle. I tried and tried and still couldn't blow the house down (sorry, wrong story) couldn't get them to budge, so I called in Tim to assist. The front sprocket is a 2 man job anyway as someone needs to stand on the rear brake which you apply brute force, but with my wiener socket wrench, we couldn't get it to move. It was the same story with the rear axle.

Luckily Paul at work has some decent wrenches and a nut cracker, and Mike has a 36mm socket which I borrowed. With these, the rear axle nut (72ft/lb) came off quite easily, but I haven't managed to get the front sprocket nut off yet (105fl/lb), but then I have been trying to press the brake myself while also using the wrench (all those years of Twister haven't paid off). So I'll call in help again probably this weekend.

So although there has been progress, it's been pretty slow, but it has been educational.

Here's a picture from a few nights ago, further bits have come off since this was taken but only little bits.

And to think I never liked naked bikes

Ninja edit: The front sprocket nut is now off too, hurrah!